CaptainZ 6 Questions 0 Answers 0 Best Answers View Profile 0 CaptainZ Asked: August 31, 20202020-08-31T11:33:15+00:00 2020-08-31T11:33:15+00:00 Why my prints won’t stick? 0 Something wrong happened with my resin printer. My prints do not stick anymore. not stickingresin printing Share Facebook 1 Answer Voted Oldest Recent surf3r 1 Question 26 Answers 1 Best Answer View Profile surf3r 2020-08-31T11:49:26+00:00Added an answer on August 31, 2020 at 11:49 am Probably it is a build plate leveling issue, make sure your leveling is 100% correct before attempting other solutions. Also you can try: – Check if Z=0? – There may be cured resin in your vat. – The FEP film may be too tight or too loose. Adjust to the correct tension, or replace. – Clean the build plate carefully with IPA or other solvents. Dry before use. – You may be using resin formulated for SLA laser or DLP printers. Try using a known resin. – Shake your resin in bottle well before using. Also stir resin in the vat. – Preheat the build plate, also the resin. You can use a hair dryer. – The build plate may have shifted, too high or too low. Try and level it again, make sure to tighten well. – The build plate may be defective. Check if the plate surface is flat. 0 Reply Share Share Share on Facebook Share on Twitter Share on LinkedIn Share on WhatsApp Leave an answerLeave an reply to surf3rCancel reply Attachment Select file Browse Click on image to update the captcha. Save my name, email, and website in this browser for the next time I comment.